Pastebin

Counter	Description
System\Processor Queue Length	Processor Queue Length is the number of threads in the processor queue.  Unlike the disk counters, this counter counters, this counter shows ready threads only, not threads that are running.  There is a single queue for processor time even on computers with multiple processors. Therefore, if a computer has multiple processors, you need to divide this value by the number of processors servicing the workload. A sustained processor queue of less than 10 threads per processor is normally acceptable, dependent of the workload.
Memory\Pages Input/Sec	Pages Input/sec is the rate at which pages are read from disk to resolve hard page faults. Hard page faults occur when a process refers to a page in virtual memory that is not in its working set or elsewhere in physical memory, and must be retrieved from disk. When a page is faulted, the system tries to read multiple contiguous pages into memory to maximize the benefit of the read operation. Compare the value of Memory\\Pages Input/sec to the value of  Memory\\Page Reads/sec to determine the average number of pages read into memory during each read operation.
PhysicalDisk\Current Disk Queue Length\<All instances>	Current Disk Queue Length is the number of requests outstanding on the disk at the time the performance data is collected. It also includes requests in service at the time of the collection. This is a instantaneous snapshot, not an average over the time interval. Multi-spindle disk devices can have multiple requests that are active at one time, but other concurrent requests are awaiting service. This counter might reflect a transitory high or low queue length, but if there is a sustained load on the disk drive, it is likely that this will be consistently high. Requests experience delays proportional to the length of this queue minus the number of spindles on the disks. For good performance, this difference should average less than two.
Network Interface\Output Queue Length\<All instances>	Output Queue Length is the length of the output packet queue (in packets). If this is longer than two, there are delays and the bottleneck should be found and eliminated, if possible. 
Network Interface\Packets Received Errors\<All instances>	Packets Received Errors is the number of inbound packets that contained errors preventing them from being deliverable to a higher-layer protocol.